Using Fall Protection On Roof Requirements

Fall protection requirements falls are the leading cause of work related injuries and deaths among roofers.

Using fall protection on roof requirements.

Using the right equipment employers must provide roofers fall protection equipment that meets osha requirements whenever they work 6 feet or more above a lower level. Subpart m requires the use of fall protection when construction workers are working at heights of 6 feet or greater above a lower level. It applies at heights of less than 6. A lack of fall protection damaged fall protection equipment or improper setup will increase their risk of falling from height.

Guardrails are a popular. A steep roof has a slope greater than 4 in 12 vertical to horizontal. The best fall protection on a roof is a parapet wall or permanent guardrail system at least 42 inches high at the roof edge. Working six feet or more above lower levels put roofers at risk for serious injury or death if they should fall.

Examples of fall protection requirements for certain. With regard to fall protection requirements applicable to the construction work itself 1926 501 b 10 low slope roofs requires conventional fall protection a combination of a monitoring system and warning line or on roofs of 50 feet or less in width a monitoring system alone i e without a warning line be used. The very high danger zone six to 15 feet from the edge requires the same precautionary. A fall protection system is required when employees are exposed to fall hazards of 4 feet or more to the ground or lower level.

There are fall protection systems available that can provide roofers the flexibility they need during demolition and roof installation.