Venetian Blind Cord Lock Stuck

When tugging the cords to the center of the blinds doesn t lower the blinds remove the blinds from the brackets.

Venetian blind cord lock stuck.

Usually this extra support does the trick. This pin holds the lock. If this does not work the pawl must be released follow these easy steps. Grasp the side cord on the blinds and raise it upward until it is level with the top rail on the blinds.

If the cords still don t pull or adjust the height of your blinds then you may need to force the lock mechanism open. First hold your lift cords level with the headrail and gently pull. It doesn t connect with lift cord. Look for the end of the cord where it is tied in a knot.

Use these directions to replace a tilted cord. Step 2 make sure that the cords can move freely. To do this carefully remove the blind from the window and lay it on a flat surface. Sometimes the cord can become lopsided or tilted after extensive use and affect how the blind functions.

Look inside the head rail to find the lock mechanism. If this does not fix the problem take your blind out of the window. To help release the lock place your hand on the middle of the bottom rail and push up while simultaneously trying to unlock the blind cord. Lift the bottom of your blinds even if they are already stuck at the top near the headrail.

You can do this with your hands and fingers. Step 1 take a look at the cords and moveable pin in the cordlock mechanismlocated inside the headrail of the blind. Use the flathead screwdriver to poke the pin inside the lock mechanism. It s important to have properly working cords on a venetian blind.

Remove the blinds by taking the headrail out of the brackets. This occurs for a variety of reasons but you can typically lower the blinds using a manual method. Untie or cut off knots at ends of tilt cord and remove pulls. It has the blind s cords running through it.

Place the screwdriver head in a perpendicular position to the head rail and press the flat surface against the pin. To release the blinds tug the lift cords to the side pulling towards the center of the blinds. If the lock malfunctions the cord and blinds will become stuck in the raised position. Tilt cord is simply threaded over pulley and out again.

Lift up and out depending on your bracket configuration to remove the blinds from the window. Step 3 if the cords are stuck or jammed take a screwdriver or needle nose pliers and move the pin to free the cords. Pull the cord toward you and cut the knot off the end of the cord. Take a screw driver and press the pawl down in the track in which it travels.

If that still doesn t work you can manually disengage the cord lock. Remove old tilt cord by pulling it out. Locate the cord lock mechanism in the headrail the lift cords run through this.